FAQ

1. My Livox sensor isn’t being detected by Livox Viewer, what should I do?

2. Why does Livox Viewer fail to recognize my Livox Mid-40?

3. I have a Mid-40 unit that works fine using a dynamic IP address through a DHCP router. However, when trying to assign a static IP address following the manual instructions, the device accepts the IP address but Livox Viewer does not display the device or recognize it.

4. How can a host PC connect to Livox LiDAR sensor units directly?

5. What is the minimum detection distance of Livox Mid?

6. How many returns does the Livox Mid support?

7. How do the point cloud data outputs from a Livox unit get converted into a common format?

8. How can I integrate Livox LiDAR units with IMU/GPS or with robotics/UAVs/drones or other products?

9. Can I run Livox SDK directly on a Windows OS?

10. What does it mean when you refer to object "reflectivity"?

11. Why is the fan in my Livox Mid unit not rotating?

12. Why is there an audible noise when running Livox LiDAR units?

13. Why does the Livox Mid-100 only have an FOV of approximately 100 degrees instead of 120 degrees?

14. What are the major highlights of the Livox Mid-40, Mid-100, Horizon, and Tele-15, respectively?

15. What enables the mass production of Livox LiDAR sensors?

16. Livox LiDAR sensors accumulate a high density over time, does that mean the real-time density is low? Why is the time-accumulation useful in practice?

17. How do Livox LiDAR sensors differ from others?

18. Why do some other LiDARs have much higher data rates, but lower coverage?

19. What is DL-Pack Technology?

20. What is the frame rate supported by Livox Mid unit sensors?